| 1. |
Remove the center console. (Refer to "Console"
in BD group) |
| 2. |
Remove the snap pin (B) and the clip (A) from
the select cable assembly.
|
| 3. |
Remove the clip (A) from the shift cable
assembly.
|
| 4. |
Remove the shift lever
assembly(A).
Tightening
torque :
8.8~13.7N.m(0.9~1.4kgf.m,
6.5~10.1lb-ft)
|
|
| 5. |
Remove the retainer(A) and
nuts(B).
|
| 6. |
Remove the select and shift cable assembly
from the transaxle. (Refer to Transaxle removal)
|
| 1. |
Check the select cable for proper operation
and for damage. |
| 2. |
Check the shift cable for proper operation and
for damage. |
| 3. |
Check the boots for
damage. |
| 4. |
Check the boots for wear abrasion sticking,
restricted movement or damage. |
| 5. |
Check for the weak or damaged
spring. |
| 1. |
Installation is the reverse of
removal. |
| 2. |
Move the slide clip (B) of guide member (A) in
the direction as shown in the illustration.
|
Adjust the slide clip fit into the
select lever moving the slide clip in the direction
(C). |
|
| 3. |
Install the guide member (A) of the select
cable (B).
|
| 4. |
Adjust the slide clip (B) to fit it into the
select lever pin (A) and install the snap pin (C).
|
Insert the slide clip in the direction
as shown in the illustration. |
| |
